- Topics: Active | Unanswered
Pages: 1
Topic closed
#1 2010-01-04 15:08:31
- **_barbarabjr_**
Captivate4 and certificate
I have recorded audio on the slide with the certificate - when I preview the slide to test - the voice cuts off after a few seconds - then when I select print and next - the voice picks up again. I think that it is the order timing - but not sure.
The order of the timing (presently) is: Certificate, slide, voice - I think should be voice, certificate, slide - but I can not change the order of the timing.
I want the slide to proceed to the next slide after I have printed and selected the next button.
Thank you
Offline
#2 2010-01-04 20:27:08
- **_Captiv8r_**
Re: Captivate4 and certificate
Hi there
When you look at the timeline for the slide, do you see a pause point indicated? (Usually these look like two vertical bars. Similar to this: || )
Perhaps the answer is to adjust the pause point of the slide so it's farther out in time and allows the audio to complete.
Cheers... Rick :)
Offline
Pages: 1
Topic closed