- Topics: Active | Unanswered
Pages: 1
Topic closed
#1 2010-04-28 09:53:11
- **_fcasbonne_**
backgroung image in front of recording zone
I resize a recording zone to integrate a background image behing (with a logo).
But when I integrate this background image (by Properties of diapo), it masks the recording zone.
Offline
#2 2010-04-30 15:20:43
- **_Captiv8r_**
Re: backgroung image in front of recording zone
So this post is a duplicate of the post before...
I tried to answer this question for you over in the Adobe forums several days ago. You then decided to repeatedly post the same question time and again in different categories. So I'm not sure if you saw my reply there.
Basically what you need to do is record initially at the smaller size. Perhaps this size is 640x480. You then rescale the project to the larger size (Perhaps 800x600) and leave the original recording centered. This should leave a blank area surrounding the main recording.
Now you create a larger image with a "cut out" that will be rendered as transparent. Essentially think of this as you would a picture frame. Place this larger image on slide 1 and make the center "cut out" transparent. Configure that image to run for the rest of the project and you should have what you want.
Cheers... Rick :)
Offline
#3 2010-04-30 15:45:50
- **_Captiv8r_**
Re: backgroung image in front of recording zone
Here is a link to a video describing the process...
Offline
Pages: 1
Topic closed