#1 2011-09-27 09:48:44

**_dennis_**

Cp 5 Missing Time Line Elements? - Here is what I found

Hello All,

I am working on a Cp 5 project, and I have one slide that has roughly 33 elements on it...this is normally more than I would have on a slide, but they are a series of staggered arrows and highlight boxes leading the viewer around a section of a report.

This morning I ran into an issue and after some frustration I figured out what to do about it and wanted to share.

The timeline is anchored to the bottom of my Cp window, and the timeline started to greyout as I moused over the elements in the timeline! This made them invisible to me and I though I had corrupted the slide, duplicating it did not help, so I deleted and rebuilt...only to have it happen again.

I found two fixes that may save you this time in the future:
1. Un-Dock the timeline. This expanded view will show all elements.
2. Expand the timeline panel  (by clicking the border of the timeline) the timeline vertically until you can see all of the elements again.

Enjoy! Hope you save some time!

Last edited by **_dennis_** (2011-09-27 09:54:27)